1. Location Selection:
   • Your Walk In Swim Spa requires a Concrete pad installed by a licensed contractor.
   • Pad requirements 20ft by 10ft Concrete Pad.
     • 5 to 6 Inches Thick, with Rebar inlayed.
     • Dig a hole 20Ft. by 8ft.,6 Inches deep, so you will be level with Ground.
   • Ask contractor for decking details.
   • Delivery to backyard is by Crane.
   • Ensure the area can support the weight of the spa, including water and occupants.
   • Confirm access to power sources and comply with local electrical codes.
2. Clearance and Accessibility:
   • Leave sufficient clearance around the spa for easy access.
   • Ensure the Walk In steps have unobstructed entry and exit paths.
3. Electrical Setup:
   • Consult a licensed electrician for proper electrical installation.
   • Walk In Swim Spa requires a USA (240V) (60 AMP Dedicated Line)
   • Adhere to the electrical specifications outlined in the user manual.
4. Water Source and Drainage:
   • Connect the spa to a clean and reliable water source.
   • Establish proper drainage to manage water changes and maintenance.
5. Professional Assistance:
   • Consider professional installation services for optimal setup.
   • Consult our customer support for guidance and assistance.

1. Water Quality:
   • Regularly test and balance the water chemistry using appropriate test kits.
   • Follow the recommended water care products to maintain water quality.
2. Filtration System:
   • Unicel Filters for Replacement (4) 50 sq ft Filters, (2) Top Filters 6ch-941, (2) Bottom Filters 6ch-942
   • Clean or replace the filters as per the specified intervals.
   • Monitor the filtration system for any signs of wear or damage.
   • For Cleaning
     Rectangle skimmer place which is above your entry steps into the spa, lift/slide up.
     Slide basket out (clean). (4) 50sgft filters (2 On top of the other).
     Turn/Spin (2) top filters, Turn/Spin (2) bottom filters.Interior look at the pump system
     You can soak/wash filters, or put all 4 filters into your dishwasher, run cycle, take out before dry/heating cycle.
     Do the reverse application for putting your filters, basket and skimmer plate back into position.
3. Surface Cleaning:
   • Use mild, non-abrasive cleaners to clean the interior and exterior surfaces.
   • Avoid harsh chemicals or abrasive tools that may damage the spa finish.
4. Walk In Steps:
   • Inspect the Walk In steps for any signs of wear or damage.
   • Keep the steps clean to ensure safe and easy entry into the spa.
5. Cover Maintenance:
   • Keep the spa cover clean and free from debris.
   • Regularly inspect the cover for any wear and tear and replace as needed.
6. Temperature Control:
   • Follow the user manual for temperature control settings.
   • Ensure the heating system is functioning properly.
7. Routine Check-ups:
   • Periodically check all components, including jets, pumps, and controls.
   • Address any issues promptly to prevent further damage.

Unicel Filters
50 sq ft Filter